Quality control is the inspection system that verifies a bulk order meets its specification before it ships: checks during production (in-line) and on finished goods (final), usually sampled to an AQL standard. It is the operational partner to the quality chapter's tests — one defines the thresholds, the other enforces them on real production.
A specification and test thresholds mean nothing without inspection to enforce them. Quality control is the practical regime of checking goods as they are made and before they leave — catching construction faults, measurement errors, color drift and defects while they can still be fixed, rather than after they reach the customer.
The backbone of goods inspection is acceptance sampling to an AQL, and the discipline is inspecting at the right points. This guide covers the inspection stages and how AQL works.
When to inspect
In-line and final inspection
Inspection happens at points where problems are still cheap to fix:
01Pre-production — checking materials and the first output against the approved standard before the run commits.
02In-line (during) — inspecting while production runs, so a systemic fault is caught early, not across the whole order.
03Final (pre-shipment) — inspecting finished, packed goods against the spec and AQL before they ship — the last gate.
04Third-party — independent inspection, often required by larger buyers, for an unbiased pass/fail.
The sampling standard
How AQL inspection works
It is rarely practical to inspect every unit, so goods are checked by acceptance sampling to an acceptance quality limit (AQL), using the sampling schemes of ISO 2859-1. A sample size is drawn from the order, defects are classed as critical, major or minor, and the lot is accepted or rejected against agreed limits for each class. Tighter AQLs allow fewer defects and are used for higher-specification goods.
AQL turns 'is the quality good enough?' into an objective, repeatable decision — but only if the spec, the standard and the defect classification are agreed in advance. The quality chapter provides the test methods that sit behind many of these checks.
Frequently asked questions
What is AQL?+
The acceptance quality limit — the worst process average, expressed as percent nonconforming or defects per 100 units, that is still considered acceptable over a series of lots under ISO 2859-1 sampling. Lot size and inspection level set the sample size, and the AQL sets the accept and reject numbers for that sample; defects are classed as critical, major or minor, each with its own limit. A tighter AQL permits fewer defects, but passing an AQL inspection does not guarantee that every unit, or any fixed percentage of the lot, is free of defects.
Why inspect during production, not just at the end?+
Because a systemic fault caught in-line can be corrected on the remaining order, while the same fault found only at final inspection may have ruined the whole run. Early inspection is cheaper to act on.
When is third-party inspection needed?+
Larger buyers and contract projects often require independent, third-party inspection for an unbiased pass/fail, especially where performance or safety is specified. It removes the conflict of a supplier grading its own work.
Sourcing certified textiles?
Vanvino® can source and document certified textiles and advise on the right standard for your market and project.
Request advice